![]() ![]() Hover over the source shape until you see the light direction arrows appear.There are two types of connectors.įloating connectors - These move around the perimeter of your shape as you move it around the drawing canvas, or change the route that the connector takes.įixed connectors - These stay attached to a fixed point on your shape, even when you move the shape around the drawing canvas. Tip: Use the Arrange tab to precisely rotate, reposition and resize shapesĬonnectors are lines that connect your shapes together and may or may not have arrows at one or both ends. Follow the steps below to draw a new connector so it goes in the right direction. If one of the connectors, the arrows between the shapes, is going in the wrong direction, you can select and delete it, just like a shape. Drag the rotate grab handle (the round arrow) at the top right corner of the shape to rotate the shape around its center point.ĭelete - Select a shape, then press Backspace or Delete, or click on the Delete tool in the toolbar. Hold down Control when you resize shapes to keep them centred. Drag any of the round ‘grab’ handles to make the shape smaller or larger. Move - Select and drag a shape that is on the drawing canvas to another position. To select multiple shapes, hold down Shift or Cmd and click on them. The Flowchart shape library is now available in the left panel. Click on the checkbox next to the Flowchart shape library’s name to enable it.Click on More Shapes at the bottom of the left panel.In addition to the shapes in the General and Advanced shape libraries, you can use shapes from the Flowchart shape library. Rectangle with a wavy bottom line - Documents that are produced as a result of a process step. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |